Payment showing pending?

If its been over 24 hours contact support with the tx hash

Yeah, the "payment pending" thing is super common, especially when the network is congested or you skimped on the fee. The original advice to check blockchain.com is solid, tbh, but let me break it down a bit more so you know exactly what you're looking for and what to do if it's stuck.

So what are the symptoms? You sent crypto (most likely BTC or LTC) to a vendor, the wallet shows it as "pending" or "unconfirmed," and it's been sitting there for hours. You're probably seeing 0 confirmations on your end, and the order page still says "awaiting payment." That's the classic scenario.

Now for the troubleshooting steps. First, grab the TXID (transaction ID) from your wallet or exchange. Paste it into a blockchain explorer—blockchain.com for BTC, blockchair.com for other coins. Then check the number of confirmations. Most vendors need 1-6 confirmations, depending on the coin and their policy. For BTC, it's usually 1 or 2. If it's stuck at 0 for a long time, look at the "fee rate" in the transaction details (sat/vB or sats per byte). If it's really low—like 1-2 sat/vB during a busy time—your transaction might never confirm on its own.

As for the fix, well, it depends. If your fee was reasonable and the network is just moving slowly, wait it out. Over the past few days, I've seen 10+ hour waits for low-fee transactions. If it's been over 24 hours with zero confirmations and the fee is tiny, you've got a few options. Some wallets support RBF (Replace-by-Fee) if you enabled it before sending. You can bump the fee to get it confirmed faster. If RBF wasn't enabled and the transaction keeps dropping from the mempool, you might need to use CPFP (Child Pays for Parent)—spending the unconfirmed UTXO with a higher fee. That's more advanced, though. Worst case, the transaction will eventually drop, the funds will come back to your wallet, and you can resend with a proper fee.

For prevention advice, always check the current network congestion before sending. Sites like mempool.space show the recommended fee rates. Use a wallet that supports RBF by default—like Electrum or some mobile wallets—so you can fix a stuck tx later. And never rely on the default fee your exchange or wallet gives you; it's often too low. Manually set a fee in the middle range for the current mempool. That way you'll avoid the pending headache entirely.